MASS AIR FLOW METER > ON-VEHICLE INSPECTION |
| 1. INSPECT MASS AIR FLOW METER |
Read the value using the intelligent tester (MAF).
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON (do not run the engine).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.
Wait 30 for seconds, and read the values on the intelligent tester.
| Tester Display | Condition | Standard Condition |
| MAF |
| 0.20 gm/sec or less |