Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE CONTROL › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR


    A095434E20
  1. Apply a light coat of engine oil to the O-ring.
    Text in Illustration 
    *1
    O-ring

    NOTICE:
    If reusing the camshaft position sensor, be sure to inspect the O-ring.

  1. Install the camshaft position sensor with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    1. Do not twist the O-ring.
    2. If a component has been dropped or subjected to a strong impact, replace it.

  1. Connect the camshaft position sensor connector.



2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH NO. 1 AIR CLEANER HOSE
  1. Install the air cleaner cap sub-assembly with No. 1 air cleaner hose to the throttle body assembly with the 2 clamps.

  1. Tighten the hose clamp.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Engage the wire harness clamp and install the wire harness to the vacuum switching valve assembly.

  1. Connect the vacuum switching valve assembly connector.

  1. Connect the mass air flow meter connector.

  1. Engage the wire harness clamp and install the wire harness to the air cleaner cap sub-assembly.

  1. Connect the No. 2 fuel vapor feed hose to the intake manifold.

  1. Install the fuel vapor feed hose to the No. 1 air cleaner hose.

  1. Connect the fuel vapor feed hose assembly to the vacuum switching valve assembly and No. 1 air cleaner hose.



3. INSTALL BATTERY
  1. Install the battery.

  1. Install the battery clamp with the 2 nuts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }



4. INSTALL NO. 2 CYLINDER HEAD COVER
  1. Install the No. 2 cylinder head cover with the 4 nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



5. INSPECT FOR ENGINE OIL LEAK