Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Apply a light coat of engine oil to the O-ring.

    NOTICE:
    If reusing the camshaft position sensor, be sure to inspect the O-ring.

  1. Install the crankshaft position sensor with the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    1. Do not twist the O-ring.
    2. If a component has been dropped or subjected to a strong impact, replace it.

  1. Connect the crankshaft position sensor connector.



2. INSPECT FOR ENGINE OIL LEAK


3. INSTALL ENGINE UNDER COVER RH (for Plastic Type)

Torque:
5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



4. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)

Torque:
18 N*m{ 184 kgf*cm , 13 ft.*lbf }