Home › Engine / Hybrid System ยท 1NZ-FE › ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE ENGINE UNDER COVER RH (for Plastic Type)


2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)


3. REMOVE CRANKSHAFT POSITION SENSOR


    A182411
  1. Disconnect the crankshaft position sensor connector.

  1. Remove the bolt and crankshaft position sensor.

    NOTICE:
    If a component has been dropped or subjected to a strong impact, replace it.