Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK SENSOR


    A172936E07
  1. Install the knock sensor onto the cylinder block with the nut as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    NOTICE:
    1. Make sure that the knock sensor is in the correct position.
    1. If a component has been dropped or subjected to a strong impact, replace it.

  1. Connect the knock sensor connector.



2. INSTALL INTAKE MANIFOLD
(Click here)