Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR (for Sensor 1)

HEATED OXYGEN SENSOR (for Sensor 1) > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR (for Sensor 1)


    A251200E01
  1. Using SST, install the heated oxygen sensor.

    SST
    09224-00010  
    Text in Illustration 
    *a
    Fulcrum Length 300 mm
    *b
    Fulcrum Length 30 mm

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    2. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    3. This torque value is effective when SST is parallel to the torque wrench.

  1. Connect the oxygen sensor connector.

  1. Install the wire harness to the wire harness bracket.



2. INSTALL OUTER COWL TOP PANEL (for LHD)
  1. Install the outer cowl top panel with the 8 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Engage the 2 clamps and install the wire harness.



3. INSTALL OUTER COWL TOP PANEL (for RHD)
  1. Install the outer cowl top panel with the 8 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Engage the 2 clamps and install the wire harness.



4. INSTALL INNER COWL TOP TO COWL BRACE (for LHD)
  1. Install the cowl top to cowl brace with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



5. INSTALL INNER COWL TOP TO COWL BRACE (for RHD)
  1. Install the cowl top to cowl brace with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



6. INSTALL FRONT NO. 1 VENTILATOR SEAL (for LHD)


C242062
  1. Disengage the clamp and remove the front No. 1 ventilator seal.



7. INSTALL FRONT NO. 1 VENTILATOR SEAL (for RHD)
  1. Engage the clip and install the front No. 1 ventilator seal.



8. INSTALL FRONT AIR SHUTTER SEAL RH (for LHD)

HINT:
Use the same procedure for the RH and LH sides.



9. INSTALL FRONT AIR SHUTTER SEAL RH (for RHD)

HINT:
Use the same procedure as for the front No. 1 ventilator seal.



10. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Click here)


11. INSPECT FOR EXHAUST GAS LEAK