Home › Engine / Hybrid System · 1NZ-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR (for Sensor 1)

HEATED OXYGEN SENSOR (for Sensor 1) > INSPECTION

for Preparation Click here



1. INSPECT HEATED OXYGEN SENSOR (for Sensor 1)


    A119369E51
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (HT1A) - 2 (+B)
    20°C (68°F)
    5.3 to 7.5 Ω
    1 (HT1A) - 4 (E2)
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Heated Oxygen Sensor)
    If the result is not as specified, replace the heated oxygen sensor.