Home › Engine / Hybrid System ยท 2NZ-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR (for Sensor 2)

HEATED OXYGEN SENSOR (for Sensor 2) > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR (for Sensor 2)


    A251202E01
  1. Using SST, install the heated oxygen sensor.
    Text in Illustration 
    *a
    Fulcrum Length 300 mm
    *b
    Fulcrum Length 30 mm

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    2. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    3. This torque value is effective when SST is parallel to the torque wrench.

  1. Pass the connector through the hole into the inside of the vehicle and install the oxygen sensor wire grommet.

  1. Connect the heated oxygen sensor connector.

  1. Install the wire harness to the wire harness bracket.



2. INSPECT FOR EXHAUST GAS LEAK


3. INSTALL REAR CONSOLE BOX ASSEMBLY
(Click here)