Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side as for the LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY


3. REMOVE REAR AXLE HUB BOLT


    C235096E02
  1. Using SST and a screwdriver or the equivalent, remove the axle hub bolt.
    Text in Illustration 
    *a
    Hold
    *b
    Turn

    SST
    09628-10011  



4. INSTALL REAR AXLE HUB BOLT


    C235097E02
  1. Install the washer and the nut onto a new axle hub bolt, as shown in the illustration.
    Text in Illustration 
    *1
    Washer
    *2
    Nut
    *a
    Hold
    *b
    Turn

    Recommended Service Nut:
    Thread Diameter
    Thread Pitch
    12.0 mm (0.472 in.)
    1.5 mm (0.0591 in.)

    HINT:
    Recommended thickness of the washer is 5 mm (0.197 in.) or more.

  1. Using a screwdriver or the equivalent to hold the axle hub, install the axle hub bolt by tightening the nut.



5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY


6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }