Home › Vehicle Interior › HEATING / AIR CONDITIONING › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEATER BLOWER MOTOR RELAY ASSEMBLY


    E223161
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      3 - 4
      Battery voltage not applied
      Below 1 Ω
      3 - 4
      Battery voltage applied to terminals 1 and 2
      10 kΩ or higher
      3 - 5
      Battery voltage not applied
      10 kΩ or higher
      3 - 5
      Battery voltage applied to terminals 1 and 2
      Below 1 Ω

      1. If the result is not as specified, replace the heater blower motor relay.