Home › Vehicle Interior › HEATING / AIR CONDITIONING › REFRIGERANT LINE

REFRIGERANT LINE > INSTALLATION

for Preparation Click here



1. INSTALL PIPING CLAMP


    I103971E01
  1. Install a new piping clamp onto the suction hose.
    Text in Illustration 
    *1
    Piping Clamp
    *2
    Groove
    *3
    Suction Hose

    NOTICE:
    Securely engage the inside step of the piping clamp in the suction hose groove.

  1. Remove the vinyl tape from the open ends of the suction tube and suction hose.

  1. Thoroughly coat a new O-ring and the contact surface of the suction hose with compressor oil (ND-OIL8).

  1. Install the 2 O-rings onto the suction hose.

    NOTICE:
    Do not let foreign matter adhere to the O-ring or O-ring seal.



    I103972E01
  1. Engage the suction tube and suction hose by matching the alignment marks.
    Text in Illustration 
    *1
    Large Diameter Section of Piping Clamp
    *2
    Alignment Mark
    *3
    Alignment Mark (yellow)

    NOTICE:
    Insert them by holding the pipe, not the piping clamp.



    I103973E01
  1. Securely insert the piping clamp to the point where the large diameter section of the piping clamp is covered by the suction tube.
    Text in Illustration 
    *1
    Large Diameter Section of Piping Clamp

    HINT:
    1. When inserting, make sure that a click sound is heard.
    2. Check that the suction tube is securely inserted by pulling it.