Home › Engine / Hybrid System ยท CRUISE CONTROL › CRUISE CONTROL SYSTEM

DTC    P0503    Vehicle Speed Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU is detected while cruise control is in operation, the ECM determines there to be a momentary interruption or noise and stores a DTC.

DTC Code
DTC Detection Condition
Trouble Area
P0503
A malfunction in the vehicle speed signal is detected while cruise control is in operation.
  1. Anti-lock brake system*1
  2. Vehicle stability control system*2
  3. Vehicle speed sensor signal circuit
  4. Vehicle speed sensor
  5. Combination meter assembly
  6. ECM
  1. *1: w/ ABS
  2. *2: w/ VSC

INSPECTION PROCEDURE

1.CHECK FOR DTC (BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS)
  1. Check for DTCs.

    HINT:
    1. w/ ABS (Click here)
    2. w/ VSC and Separate Type Yaw Rate Sensor (Click here)
    3. w/ VSC and Built-in Type Yaw Rate Sensor (Click here)

    OK:
    DTCs are not output.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (w/ ABS)
    B
    DTC is output (w/ VSC and Separate Type Yaw Rate Sensor)
    C
    DTC is output (w/ VSC and Built-in Type Yaw Rate Sensor)
    D



B
GO TO ANTI-LOCK BRAKE SYSTEM (Click here)

C
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)

D
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
A


2.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more.

    2. Turn the cruise control main switch on.

    3. Push the cruise control main switch to -SET to activate cruise control.

  1. Check for DTCs (Click here).

    OK:
    DTC P0503 is not output.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 2NZ-FE)
    B
    NG (for 1NZ-FE)
    C



B
GO TO SFI SYSTEM (Click here)

C
GO TO SFI SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)