STEERING GEAR > REASSEMBLY |
| 1. INSTALL NO. 2 STEERING RACK BOOT |
![]() |
Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot.
![]() | Lithium soap base glycol grease |
Install the No. 2 steering rack boot to the groove on the rack housing.
| 2. INSTALL NO. 1 STEERING RACK BOOT |
| 3. INSTALL NO. 2 STEERING RACK BOOT CLAMP |
![]() |
Using SST, tighten a new steering rack boot clamp as shown in the illustration.
| *a | Hold |
| *b | Turn |
| 4. INSTALL NO. 1 STEERING RACK BOOT CLAMP |
| 5. INSTALL STEERING RACK BOOT CLIP (for LH Side) |
![]() |
Using pliers, install the rack boot clips as shown in the illustration.
| *a | Upper Side |
| *b | Front Side |
| *c | 180° (Clip installation range) |
| 6. INSTALL STEERING RACK BOOT CLIP (for RH Side) |
| 7. INSTALL TIE ROD END SUB-ASSEMBLY LH |
Install the lock nut and the tie rod end sub-assembly LH onto the steering gear until the matchmarks are aligned.
| 8. INSTALL TIE ROD END SUB-ASSEMBLY RH |
| 9. INSPECT STEERING GEAR ASSEMBLY |
![]() |
Using SST, rotate the pinion shaft to see if both the left and the right steering rack boots expand and contract smoothly.