Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY
  1. Engage the 2 claws to install the hazard warning signal switch assembly.



2. INSTALL INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY (w/o Radio Receiver)
  1. Connect the connector.

  1. Engage the 7 clips and install the instrument cluster finish center panel.



3. INSTALL INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY (w/ Radio Receiver)
  1. Connect the connector.

  1. Engage the 4 clips and install the instrument cluster finish center panel.



4. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY


    B290374
  1. Engage the 4 guides and 10 clips and install the instrument cluster finish panel garnish.