HAZARD WARNING SWITCH > REMOVAL |
| 1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY |
![]() |
Disengage the 10 clips and the 4 guides and remove the instrument cluster finish panel garnish.
| 2. REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY (w/o Radio Receiver) |
![]() |
Disengage the 7 clips.
Disconnect the connector and remove the instrument cluster finish center panel.
| 3. REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY (w/ Radio Receiver) |
![]() |
Disengage the 4 clips.
Disconnect the connector and remove the instrument cluster finish center panel.
| 4. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY |
![]() |
Disengage the 2 claws to remove the hazard warning signal switch assembly.