Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    E136319E27
  1. Check the hazard warning signal light switch function.
    Text in Illustration 
    *a
    Component without harness connected
    (Hazard Warning Signal Switch Assembly)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance::
      Tester Connection
      Switch Condition
      Specified Condition
      1(E) - 4(TB)
      Pushed
      Below 1 Ω
      Not pushed
      10 kΩ or higher

      If the result is not as specified, replace the hazard warning signal light switch assembly.



    E136319E27
  1. Check the illumination operation.
    Text in Illustration 
    *a
    Component without harness connected
    (Hazard Warning Signal Switch Assembly)

    1. Apply battery voltage to the hazard warning signal light switch assembly connector.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 3(ILL+)
      Battery positive (-) → 2(ILL-)
      The illumination comes on

      If the result is not as specified, replace the hazard warning signal light switch assembly.