Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › SIDE MUDGUARD

SIDE MUDGUARD > INSTALLATION

for Preparation Click here



1. INSTALL SIDE MUDGUARD PROTECTOR
  1. Using a piece of cloth, rub the remaining double-sided adhesive tape off the side mudguard protector.

    NOTICE:
    Installing the side mudguard protector with any double-sided tape remaining on the side mudguard may cause adhesion failure. Therefore, completely remove the double-sided tape.

  1. Using a non-residue solvent, clean the attachment surface.

  1. Apply Primer M to the installation part of the side mudguard.

    HINT:
    If primer is applied to an area that is not specified, wipe off the primer with a non-residue solvent before it dries.

  1. Install a new side mudguard protector onto the side mudguard.

    NOTICE:
    1. Allow the primer to dry for 3 minutes or more.
    2. Throw away any leftover primer.
    3. Do not apply too much primer.



2. INSTALL SIDE MUDGUARD REAR PROTECTOR
  1. Using a piece of cloth, rub the remaining double-sided adhesive tape off the side mudguard rear protector.

    NOTICE:
    Installing the side mudguard rear protector with any double-sided tape remaining on the side mudguard may cause adhesion failure. Therefore, completely remove the double-sided tape.

  1. Using a non-residue solvent, clean the attachment surface.

  1. Apply Primer M to the installation part of the side mudguard.

    HINT:
    If primer is applied to an area that is not specified, wipe off the primer with a non-residue solvent before it dries.

  1. Install a new side mudguard rear protector onto the side mudguard.

    NOTICE:
    1. Allow the primer to dry for 3 minutes or more.
    2. Throw away any leftover primer.
    3. Do not apply too much primer.



3. INSTALL SIDE MUDGUARD SUB-ASSEMBLY
  1. Engage the 7 clips and install the side mudguard.

  1. Install the 8 retainers.

  1. Tighten the screw.



4. INSTALL ROCKER PANEL MOULDING COVER
  1. Engage the 2 claws and install the rocker panel moulding cover.