SIDE MUDGUARD > REMOVAL |
| 1. REMOVE ROCKER PANEL MOULDING COVER |
![]() |
Using a moulding remover, disengage the 2 claws and remove the rocker panel moulding cover.
| *1 | Moulding Remover |
| 2. REMOVE SIDE MUDGUARD SUB-ASSEMBLY |
![]() |
Remove the screw.
Remove the 8 retainers.
![]() |
Disengage the 7 clips and remove the side mudguard.
| 3. REMOVE SIDE MUDGUARD REAR PROTECTOR |
![]() |
While peeling off the double-sided adhesive tape, remove the side mudguard rear protector.
| 4. REMOVE SIDE MUDGUARD PROTECTOR |
![]() |
While peeling off the double-sided adhesive tape, remove the side mudguard protector.