P0614-ECM/TCM INCOMPATIBLE

For a complete wiring diagram Refer to Section 8W

Theory of Operation

The Transmission Control Module (TCM) performs various internal tests to verify proper controller operation. If the TCM detects that the variables that dictate the vehicle application are not present a DTC will set.

When Monitored:
Continuously with the ignition on.
Set Condition:
If the TCM detects that the ECM software level is incompatible with the TCM software level.

Possible Causes

CONTROLLER(S) NOT PROPERLY CODED

TRANSMISSION CONTROL MODULE

Always perform the NAG1 Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)

Diagnostic Test

1. CHECK IF TCM IS FLASHABLE

With the scan tool, record the vehicles TCM and PCM/ECM part numbers.
Verify the model year and make of both the TCM and ECM/PCM part numbers.
Flash and program the controller(s) with the correct software that corresponds with year and make of the vehicle. Refer to the Service Information for proper programing procedures.

Were you able to update (flash) the controller(s) successfully to the proper software levels?

Yes

Test Complete.

Perform NAG1 TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)

Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM per the Service Information. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - DESCRIPTION)
Perform NAG1 TRANSMISSION VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - NAG1 - STANDARD PROCEDURE)