INSTALLATION
FRONT
1. Remove and clean all rust and debris from the anti-rattle clip mounting surfaces (3) on the brake caliper adapter (2).
2. Install new anti-rattle clips (3) into the caliper adapter (2).
3. Install the inboard and outboard brake pads (4) onto the caliper adapter (2).
4. Install caliper (5) on the caliper adapter (2).
5. Install the caliper slide pin bolts (2) and tighten to 44 N·m (32 ft. lbs.).
6. Install wheel and tire assembly.
7. Remove support and lower vehicle.
8. Pump brake pedal until caliper pistons and brake pads are seated and a firm brake pedal is obtained.
9. Fill brake fluid.
REAR
1. Install the inboard & outboard brake pads onto the caliper.
2. Lubricate the slide pins and slide pin bushings with caliper slide grease or the grease provided with the brake pads.
3. Install caliper (1) on the anchor.
4. Install the caliper slide pin bolts (4) and tighten to 25 N·m (18 ft. lbs.).
5. Install wheel and tire assembly.
6. Remove support and lower vehicle.
7. Pump brake pedal until caliper piston and brake pads are seated and a firm brake pedal is obtained.
8. Fill brake fluid level if necessary.