BRAKE LINES
DESCRIPTION
Flexible rubber hose is used at both front brakes, rear brakes and at the rear axle junction block. Double walled steel tubing is used. Double inverted style and ISO style flares are used on the brake lines.
REMOVAL
1. Install a brake pedal prop rod.
2. Siphon the master cylinder reservoir.
3. Remove the Primary or Secondary brake tubes at the master cylinder.
4. Remove the Primary or Secondary brake tubes at the HCU.
INSTALLATION
1. Install the primary or secondary brake tubes to the master cylinder.
2. Install the primary or secondary brake tubes to the HCU.
3. Remove the brake pedal prop rod.
4. Fill and bleed the brake system.