B124D-PTS SENSOR 2 RING TIME TOO LONG
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
While the vehicle is in reverse or neutral for speeds less than 16km/h.
- Set Condition:
Data line stuck at 0.
| Possible Causes |
| PARK ASSIST SENSOR NO. 2 |
Diagnostic Test
1. CHECK FOR ACTIVE DTC: B124D-PTS SENSOR 2 RING TIME TOO LONGTurn the ignition on.
Apply the vehicle park brake.
Shift the transmission into Reverse.
With the scan tool, record and erase Park Assist Module DTCs.
Wait 30 seconds.
With the scan tool, read Park Assist Module DTCs.
Is DTC: B124D-PTS SENSOR 2 RING TIME TOO LONG?
Yes
- Go To 2
No
- The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
2. REPLACE PARK ASSIST SENSOR NO. 2
View Repair
Repair
- Replace Park Assist Sensor No. 2 in accordance with the service information.
- Perform BODY VERIFICATION TEST VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)