2007 Commander XK Factory Service Manual 24 - HEATING & AIR CONDITIONING

*HVAC SYSTEM TEST (ATC)

For a complete wiring diagram Refer to Section 8W.

Theory of Operation


The HVAC System Test provides a starting point in the diagnostic process by identifying the appropriate diagnostic procedure or system test to perform when diagnosing a given symptom, condition, or DTC. It also provides a means for testing the entire HVAC system by utilizing the A/C Heater Control's On-Board System Tests. The On-Board System Tests can also assist in diagnosing stored DTCs. (Refer to 24 - HEATING & AIR CONDITIONING - DIAGNOSIS AND TESTING) for additional information about on-board diagnostics.



Diagnostic Test

1. HVAC SYSTEM TEST

NOTE: Diagnose and repair all active DTCs before diagnosing and repairing stored DTCs.



Make a selection based on the symptom, condition, or DTC that you want to diagnose.

For Any Active DTC


Scan Tool Indicates HVAC Not Active On Bus


Complete HVAC System Test


A/C System Performance Test


General System Operation & Function Test


Actuator Calibration Test


Front Blower Motor Inoperative


Rear Blower Motor Inoperative


Rear Blend Door Inoperative


Rear Mode Door Inoperative

2. A/C SYSTEM PERFORMANCE TEST

NOTE: The following are prerequisites of the Cooldown Test. Verify each of the following before running the test:


Once all of the prerequisites have been met, actuate the Cooldown Test by performing the following:
Start the engine.
With the scan tool in HVAC, select System Tests and then select Cooldown test.

NOTE: The Cooldown Test can take up to two minutes to run. While the test is running, the A/C status indicator will flash. If the test passes, the A/C status indicator will stop flashing. However, if the test fails, both the A/C and EBL status indicators will flash alternately and an active DTC B10B2 will set. The status indicators will continue to flash until either a successful Cooldown Test is executed or until the vehicle is driven a specified number of miles or after 5 ignition cycles. In addition, DTC B10B2 will remain active until a successful Cooldown Test is executed. The test will stop running if any of the following occurs:


Allow the test to run to completion before proceeding.
With the scan tool, select View DTCs.

Does the scan tool display any DTCs?

Yes


No

3. GENERAL SYSTEM OPERATION & FUNCTION TEST

NOTE: If at anytime a DTC becomes active during this test, proceed to the conclusion question.

NOTE: If multiple DTCs become active, diagnose those that relate to a short circuit first.


If not done so previously, start the engine.
Turn the blower control to manual low.
Turn the Left and Right Blend controls to full cold.
Turn the Mode control to panel.
Monitor the scan tool for active HVAC DTCs while performing the following test steps.
Press the A/C mode switch on, wait 30 seconds, press it off, and then proceed to the next step.
Press the Rear Defrost mode switch on, wait 30 seconds, press it off, and then proceed to the next step.
Press the Recirculation mode switch on, wait 30 seconds, press it off, and then proceed to the next step.
Turn the Left Blend control to full hot, wait 30 seconds, turn it to full cold, and then proceed to the next step.
Turn the Right Blend control to full hot, wait 30 seconds, turn it to full cold, and then proceed to the next step.
Turn the Mode control to every door position. Leave it in each position for 30 seconds.

Does the scan tool display any active DTCs?

Yes


No

4. ACTUATOR CALIBRATION TEST

If not done so previously, start the engine.
With the scan tool, select System Tests and then select Actuator Calibration Test. When the test is complete, select View DTCs.

Does the scan tool display any DTCs?

Yes


No