B213F-IGNITION START (REMOTE START) CONTROL CIRCUIT LOW
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
The Front Control Module is not configured correctly setting a false DTC that does not apply to this vehicle.
| Possible Causes |
| FRONT CONTROL MODULE NOT CONFIGURED CORRECTLY |
Diagnostic Test
1. CHECK FOR ACTIVE DTC AND DETERMINE FCM CONFIGURATIONWith the scan tool, read the active DTC's.
Cycle the ignition switch from off to on at least 5 times, leaving the ignition on for a minimum of 90 seconds per cycle.
With the scan tool, read the active DTC's.
Does the scan tool display this DTC as active?
Yes
- With the scan tool enter program network configuration and program the FCM to the vehicle configuration, erase DTC's and retest.
No
- If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals. Erase the stored DTCs.