B16AA-HIGH BEAM CAMERA ALIGNMENT PERFORMANCE- BOTTOM
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
The DTC will be set if the target light source is not within the correctable limits of the mirror.
| Possible Causes |
| SMART BEAM CALIBRATION |
Diagnostic Test
1. TEST FOR INTERMITTENT CONDITIONWith the scan tool, record and erase DTC's.
Does the scan tool display: B16AA-HIGH BEAM CAMERA ALIGNMENT PERFORMANCE- BOTTOM?
Yes
- Perform Smart Beam Calibration. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/SMARTBEAM - STANDARD PROCEDURE)
No
- Test complete.