B224E-POWER LIFTGATE MODULE INTERNAL
For a complete wiring diagram Refer to Section 8W
- When Monitored:
Whenever the battery is connected.
- Set Condition:
When the Power Liftgate Module senses an internal problem, this code will set.
| Possible Causes |
| TROUBLE CODE PRESENT |
| POWER LIFTGATE MODULE |
Diagnostic Test
1. DTC PRESENTWith the scan tool, record and erase DTCs.
Cycle the ignition switch from On to Off.
Wait 30 seconds.
Turn the ignition on.
With the scan tool, read DTCs.
Does the scan tool display POWER LIFTGATE MODULE INTERNAL?
No
- Operate the power liftgate open and closed several times. With the scan tool, read DTCs. If this code appears, replace the Power Liftgate Module in accordance with service information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).
Yes
- Replace the Power Liftgate Module in accordance with service information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).