B1912-PASSENGER WINDOW SWITCH CIRCUIT HIGH-PDM
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
Continuously
- Set Condition:
When the Passenger Window Express Switch Mux circuit is over 5.6 volts for over 100 ms.
| Possible Causes |
| (Q336) PASSENGER WINDOW EXPRESS SWITCH MUX CIRCUIT SHORT TO VOLTAGE |
| PASSENGER WINDOW/DOOR LOCK SWITCH |
| PASSENGER DOOR MODULE |
Diagnostic Test
1. TEST FOR INTERMITTENT CONDITIONWith the scan tool, record and erase DTC's
Operate the Passenger Window Switch in both positions several times.
Cycle the ignition from on to off.
Turn the ignition on.
With the scan tool, read DTC's.
Does the scan tool display B1912–PASSENGER WINDOW SWITCH CIRCUIT HIGH?
Yes
- Go To 2
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
2. PASSENGER WINDOW/DOOR LOCK SWITCH SHORTED
With the scan tool, erase DTC's.
Disconnect the Passenger Window/Door Lock Switch C2 connector.
Turn the ignition on.
With the scan tool, read DTC's.
Does the scan tool display B1912–PASSENGER WINDOW SWITCH CIRCUIT HIGH?
No
- Replace the Passenger Window/Door Lock Switch.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
Yes
- Go to 3
3. (Q336) PASSENGER WINDOW EXPRESS SWITCH MUX WIRE SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the Passenger Door Module C2 connector.
Turn the ignition on.
Measure the voltage between ground and the (Q336) Passenger Window Express Switch Mux circuit in the Passenger Door Module C2 connector.
Is there any voltage present?
Yes
- Repair the (Q336) Passenger Window Express Switch Mux circuit for a short to voltage.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Replace the Passenger Door Module in accordance with service information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)