*FRONT WINDOW MOVES ABOUT 3 INCHES AND QUITS
NOTE: The Driver circuits are shown but the Passenger side is similar.
For a complete wiring diagram Refer to Section 8W.
| Possible Causes |
| WINDOW HALL SENSOR A OR SENSOR B SIGNAL CIRCUITS OPEN |
| WINDOW MOTOR (HALL SENSOR OPEN) |
Diagnostic Test
1. TEST FOR DIAGNOSTIC TROUBLE CODESTurn the ignition on.
With the scan tool, read DTC's.
Does the scan tool display any Power Window related DTC's?
No
- Go To 2
Yes
- Refer to symptom list for problems related to POWER WINDOWS.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
2. WINDOW HALL SENSOR A AND SENSOR B SIGNAL CIRCUIT OPEN
Disconnect the appropriate Door Module C2 connector.
Disconnect the appropriate Window Motor connector.
Measure the resistance of the Window Hall Sensor A Signal circuit between the Motor connector and the Module C2 connector.
Measure the resistance of the Window Hall Sensor B Signal circuit between the Motor connector and the Module C2 connector.
Is the resistance below 2.0 ohms on both Signal circuits?
No
- Repair the Window Hall Sensor Signal circuit(s) for opens.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
Yes
- Replace the Window Motor.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)