2007 Commander XK Factory Service Manual 8 - ELECTRICAL

DIAGNOSIS AND TESTING

Rear Camera

Any diagnosis of the Camera and Audio system should begin with the use of a scan tool and the appropriate Diagnostic Service information.

Refer to the appropriate wiring information.

WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.


CONDITION
 
POSSIBLE CAUSES
 
CORRECTION
 
CAMERA INOPERATIVE
 

1. Fuse inoperative

 

1. Check the rear tail lamp/back up fuse. Replace fuse, if required

 

2. Wiring damaged

 

2. Check for battery voltage at the camera connector. Repair wiring if required.

 
 

3. Camera ground damaged.

 

3. Check for continuity between the ground wire at the camera connector and ground. Repair wiring if required.

 
 

4. Video wiring damaged.

 

4. Check for continuity between the radio connector and the camera connector. There should be continuity. Repair ground, if required.

 
 

5. Camera inoperative.

 

5. Replace the camera. Refer to the appropriate Service Information.

 
 
NO VIDEO DISPLAY
 

1. Fuse inoperative.

 

1. Check radio fuse and Ignition-Off Draw (IOD) fuse in Integrated Power Module (IPM). Replace fuses, if required.

 

2. Radio connector damaged.

 

2. Check for loose or corroded radio connector. Repair, if required.

 
 

3. Wiring damaged.

 

3. Check for battery voltage at radio connector. Repair wiring, if required.

 
 

4. Radio ground damaged.

 

4. Check for continuity between radio chassis and a known good ground. There should be continuity. Repair ground, if required.

 
 

5. Video wiring damaged.

 

5. Check for continuity between the radio connector and the camera connector. There should be continuity. Repair ground, if required.

 
 

6. Radio inoperative.

 

6. Refer to appropriate Diagnostic Service Information.