B1B91-DRIVER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on the ORC monitors the Seat Track Position Sensors circuits.
- Set Condition:
If the module detects current on the Seat Track Position Sensors circuits and the module is not configured for STPS.
| Possible Causes |
| DRIVER SEAT TRACK POSITION SENSOR |
| WIRING |
| OCCUPANT RESTRAINT CONTROLLER (ORC) |
Diagnostic Test
1. CHECK FOR ACTIVE INTERNAL FAULTS, IGNITION FAULTS, AND BATTERY FAULTS IN THE OCCUPANT RESTRAINT CONTROLLER (ORC)NOTE: Ensure the battery is fully charged.
With the scan tool, read Occupant Restraint Controller (ORC) DTCs.
Does the scan tool display any active DTCs relating to internal faults, ignition faults, or battery faults?
Yes
- Diagnose and repair the DTCs. Refer to the Table of Contents in this Section for a complete list of symptoms.
No
- Go To 2
2. VERIFY THAT B1B91-DRIVER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH IS ACTIVE
With the scan tool, erase ORC DTCs.
Turn the ignition off, wait 10 seconds and then turn the ignition on.
Wait 2 minutes, and then with the scan tool, read ORC DTCs.
Does the scan tool display active: B1B91-DRIVER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH?
Yes
- Go To3
No
- Perform the *ORC VERIFICATION TEST-VER. 1
3. VERIFY WIRING
Turn the ignition off.
Inspect the driver seat wiring for Seat Position Sensors.
Are Seat Position Sensor(s) present?
Yes
WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and personal injury or death.
Replace the ORC in accordance with the Service Information.- Perform the *ORC VERIFICATION TEST-VER. 1
No
- Perform the *ORC VERIFICATION TEST-VER. 1