B1BC7-DEPLOYMENT DATA RECORD FULL

When Monitored:
With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.
Set Condition:
This DTC will set if the module identifies an out of range internal circuit.

Possible Causes

OCCUPANT RESTRAINT CONTROLLER

Diagnostic Test

1. CHECK FOR ACTIVE DTC

Turn the ignition on.
With the scan tool, read ORC DTCs.

Is the Deployment Data Record Full DTC active?

Yes

Go To 2

Perform the *ORC VERIFICATION TEST - VER 1.

2. REPLACE THE OCCUPANT RESTRAINT CONTROLLER

WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and personal injury or death.

View repair.

Repair

Replace the Occupant Restraint Controller in accordance with the service information.
Perform the *ORC VERIFICATION TEST - VER 1.