U1414-IMPLAUSIBLE/MISSING ECU CONFIGURATION DATA
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on. The ORC on board diagnostics continuously monitors the CAN Bus message from the FCM containing the ORC Configuration Data.
- Set Condition:
This DTC will set if the appropriate CAN Bus message is not received by the ORC.
| Possible Causes |
| FRONT CONTROL MODULE |
Diagnostic Test
1. FRONT CONTROL MODULE FAILURETurn the ignition on.
With the scan tool, read FCM DTCs.
Does the scan tool display any Front Control Module DTCs?
Yes
- Select appropriate symptom from Symptom List. Repair all FCM active DTCs and before diagnosing the ORC DTCs.
No
- Replace the Front Control Module in accordance with the Service Information.
- Perform the *ORC VERIFICATION TEST-VER. 1