SEAL-REAR OUTPUT SHAFT
REMOVAL
1. Remove the rear propeller shaft. (Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT/PROPELLER SHAFT - REMOVAL)
2. Using Holder C-3281 (1), remove the rear companion flange (2) nut.
3. Remove the rear output flange (1) from the main shaft (2). If necessary, use a suitable 2 or 3 jaw puller to remove the output shaft flange.
4. Remove the rear output seal with a suitable pry tool or a screw mounted in a slide hammer.
INSTALLATION
1. Install a new rear output seal into the rear cover with Installer C-3972A.
2. Install the rear output flange (1) onto the main shaft (2).
3. Using Holder C-3281 (1), install the rear companion flange (2) nut. Tighten the nut to 122-176 N·m (90-130 ft.lbs.).
4. Install the rear propeller shaft. (Refer to 3 - DIFFERENTIAL & DRIVELINE/PROPELLER SHAFT/PROPELLER SHAFT - REMOVAL)
5. Check the transfer case fluid level. (Refer to 21 - TRANSMISSION/TRANSFER CASE/FLUID - STANDARD PROCEDURE) Correct as necessary.