B1A24-KEY NOT PROGRAMMED
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition switch on.
| Possible Causes |
| KEY NOT PROGRAMMED |
| SKREEM |
Diagnostic Test
1. KEY NOT PROGRAMMEDTurn the ignition on.
Using a scan tool, attempt to program the key(s) into the SKREEM.
Was the programming of the key(s) successful?
Yes
- Programming of the key(s) were successful. Test complete.
- Perform SKREEM VERIFICATION TEST. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE)
No
- Replace the ignition key and attempt to program it into the SKREEM. If the DTC resets, replace and program the SKREEM in accordance with the Service Information.
NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the SKREEM.
- Perform SKREEM VERIFICATION TEST. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE)