P0219-ENGINE OVERSPEED
For a complete wiring diagram Refer to Section 8W.
Theory of Operation
The Transmission Control Module (TCM) receives a engine rpm over the CAN bus. If the engine rpm exceeds a predetermined value a DTC will set.
- When Monitored:
Ignition on, engine running with the transmission in a valid forward gear.
No active CAN Bus DTCs present.
System voltage between 9.0 and 16 volts.
- Set Condition:
Monitored engine speed over the CAN Bus is greater than 6800 rpm for the period of 100 msecs.
| Possible Causes |
| ENGINE MECHANICAL PROBLEM |
| TRANSMISSION MECHANICAL PROBLEM |
| POWERTRAIN CONTROL MODULE |
| TRANSMISSION CONTROL MODULE |
Always perform the CVT Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)
Diagnostic Test
1. CHECK FOR OTHER TRANSMISSION DTCSWith the scan tool, check for other transmission DTCs.
Are there any TCC, gear ratio and/or speed sensor DTCs present in addition to P0219?
Yes
- Refer back to the CVT Transaxle Diagnosis and Testing category and perform the appropriate symptom. If speed sensor DTCs are present, perform their respective tests first.
No
- Go To 2
2. CHECK FOR ENGINE DTCS
With the scan tool, check for engine DTCs.
Are there any engine DTCs present?
Yes
- Refer back to the Engine Diagnosis and Testing category and perform the appropriate symptom.
- Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)
No
- Go To 3
3. CHECK IF DTC RESETS
With the scan tool erase transmission DTCs.
Test drive the vehicle and try to duplicate the setting conditions.
Pick the answer that best describes your findings:
DTC resets with a speed sensor DTC
- Refer to the Transmission Diagnostic and Testing category and perform the appropriate symptom.
DTC resets without a speed sensor DTC
- Replace or repair the CV Transmission as necessary per the Service Information.
- Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)
No
- Go To 4
4. INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
Wiggle the wires while checking for shorted and open circuits.
Were there any problems found?
Yes
- Repair as necessary.
- Perform CVT VERIFICATION TEST. (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - CVT - STANDARD PROCEDURE)
No
- Test Complete.