P0630-VIN NOT PROGRAMMED IN PCM
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
At initialization.
- Set Condition:
The VIN has not been programmed into the PCM. One Trip Fault. Three good trips to turn off the MIL.
| Possible Causes |
| VIN NOT PROGRAMMED IN THE POWERTRAIN CONTROL MODULE (PCM) |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - STANDARD PROCEDURE).
Diagnostic Test
1. VIN NOT PROGRAMMED IN THE POWERTRAIN CONTROL MODULE (PCM)Ignition on, engine not running.
Using the scan tool, program the VIN into the Powertrain Control Module (PCM).
Start the engine and allow it to reach normal operating temperature.
NOTE: If the engine will not start, crank the engine for 15 seconds. Crank at least 2 times with the ignition switch returning to the off position each time.
With a scan tool, select View DTCs.
Is the status Active for this DTC?
Yes
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information.
- Perform the PCM Verification Test Ver. 1 (Refer to 9 - ENGINE - STANDARD PROCEDURE).
No
- Test complete.
- Perform the PCM Verification Test Ver. 1 (Refer to 9 - ENGINE - STANDARD PROCEDURE).