P0632-ODOMETER NOT PROGRAMMED IN PCM
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
Ignition on.
- Set Condition:
The vehicle mileage is not programed into the PCM. One Trip Fault. Three good trips to turn off the MIL.
| Possible Causes |
| MILEAGE NOT PROGRAMMED IN THE POWERTRAIN CONTROL MODULE (PCM) |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - STANDARD PROCEDURE).
Diagnostic Test
1. MILEAGE NOT PROGRAMMED IN THE POWERTRAIN CONTROL MODULE (PCM)Ignition on, engine not running.
With a scan tool, Clear DTCs.
Using the scan tool, program the vehicle mileage into the Powertrain Control Module (PCM).
Start the engine and allow it to reach normal operating temperature.
With a scan tool, select View DTCs.
Is the status Active for this DTC?
Yes
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information.
- Perform the PCM Verification Test Ver. 1 (Refer to 9 - ENGINE - STANDARD PROCEDURE).
No
- Test complete.
- Perform the PCM Verification Test Ver. 1 (Refer to 9 - ENGINE - STANDARD PROCEDURE).