U0121-LOST COMMUNICATION WITH ANTI-LOCK BRAKE MODULE
For a complete wiring diagramRefer to Section 8W.
- When Monitored:
Ignition run time is greater than 1 second. Battery voltage between 9 and 16 volts. Engine run time greater than 3 seconds.
- Set Condition:
The PCM doesn't receive an ABS message over the CAN C circuit for 7 consecutive seconds. The circuit is continuously monitored.
| Possible Causes |
| CAN C BUS OPEN OR SHORTED CONDITION |
| ANTI-LOCK BRAKE (ABS) MODULE |
| FRONT CONTROL MODULE (FCM) |
| POWERTRAIN CONTROL MODULE (PCM) |
Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diagnostic procedures and for further possible causes.
Diagnostic Test
1. ACTIVE DTCIgnition on, engine not running.
With a scan tool, select View DTCs.
Is the status Active for this DTC?
Yes
- Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - DIAGNOSIS AND TESTING for diagnostic procedures and for further possible causes.
No
- Refer to the *CHECKING FOR AN INTERMITTENT DTC Diagnostic Procedure. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING)
- Perform the PCM Verification Test Ver. 1 (Refer to 9 - ENGINE - STANDARD PROCEDURE)