B123F-MENU SWITCH STUCK
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
With the ignition on.
- Set Condition:
The Instrument Cluster detects the Menu Switch active for greater than 20 seconds.
| Possible Causes |
| CLUSTER |
Diagnostic Test
1. CHECK FOR AN ACTIVE DTCTurn the ignition on.
With the scan tool, record and erase DTCs.
Press the MENU switch three times.
With the scan tool, read DTCs.
Does the scan tool display: B123F-MENU SWITCH STUCK?
Yes
- Replace the Cluster in accordance with the service information.
- Perform BODY VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Test complete