PANEL - B-PILLAR TRIM, LOWER
REMOVAL
1. Adjust the front seat to its most forward position for easiest access to the front seat belt lower anchor cover (1) and the B-pillar trim.
2. Grasp the upper edge of the lower anchor cover and pull upward to unsnap it from the front seat cushion outboard side shield (4).
3. Remove the screw (2) that secures the seat belt (3) lower anchor to the outboard side of the front seat cushion frame.
4. Remove the screw (3) that secures the seat belt turning loop to the height adjuster on the upper B-pillar.
5. Remove the seat belt turning loop from the height adjuster.
6. Release the upper retaining clips and separate the lower B-pillar trim (2) from the pillar, pull seat belt (4) through the hole and remove.
INSTALLATION
1. Position the seat belt through the hole in the lower B-pillar trim.
2. Position the lower tabs (3) into the scuff plate (4) and seat the upper retaining clips (1) fully.
3. Install and tighten the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 40 N·m (30 ft. lbs.).
4. Position the seat belt (3) lower anchor to the mounting hole on the outboard side of the front seat cushion frame. Be certain that the seat belt webbing between the turning loop and the lower anchor is not twisted.
5. Install and tighten the screw (2) that secures the lower anchor to the seat. Tighten the screw to 51 N·m (37.5 ft. lbs.).
6. Install the lower anchor cover (1) onto the front seat cushion outboard side shield (4).