INSTALLATION
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
1. Align the base of the bulb with the park/turn signal lamp socket (1).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the park/turn signal lamp housing (4).
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reconnect the engine compartment wire harness connector (2) to the bulb socket connector receptacle.
7. Position the front of the front wheel house splash shield (4) to the front fascia (2) closure panel and secure it with two push pin fasteners (3).
8. Install the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
9. Install and tighten the three screws (1) that secure the outboard side of the splash shield to the front fascia. Tighten the screws to 2 N·m (19 in. lbs.).
10. Reinstall the front wheel and tire. (Refer to 22 - TIRES/WHEELS - INSTALLATION).
11. Lower the vehicle.
12. Reconnect the battery negative cable.
LAMP
1. Position the park/turn signal lamp into the seat in the face of the front fascia (4). Be certain that the three alignment tabs on the lamp housing are engaged in the alignment slots in the seat.
2. Install and tighten the three screws (5) that secure the lamp to the back of the fascia. Tighten the screws to 2 N·m (14 in. lbs.).
3. Reconnect the engine compartment wire harness (1) connector (3) to the park/turn signal bulb socket (2) connector receptacle.
4. Position the front of the front wheel house splash shield (4) to the front fascia (2) closure panel and secure it with two push pin fasteners (3).
5. Install the push pin fastener (3) that secures the inboard side of the splash shield to the front end sheet metal.
6. Install and tighten the three screws (1) that secure the outboard side of the splash shield to the front fascia. Tighten the screws to 2 N·m (19 in. lbs.).
7. Reinstall the front wheel and tire. (Refer to 22 - TIRES/WHEELS - INSTALLATION).
8. Lower the vehicle.
9. Reconnect the battery negative cable.