DIAGNOSIS AND TESTING
POWER MIRROR SWITCH - LHD
1. Disconnect and isolate the battery negative cable.
2. Remove power mirror switch (Refer to 8 - ELECTRICAL/POWER MIRRORS/POWER MIRROR SWITCH - REMOVAL).
3. Using an ohmmeter, test for continuity between the terminals of the switch as shown in the Mirror Switch Test table.
4. If test results are not obtained as shown in the Mirror Switch Test table, replace the switch.
SWITCH POSITION MOVE BUTTON | CONTINUITY BETWEEN TERMINALS |
| MIRROR IN "L" POSITION | |
| UP | PIN 2 TO 4 PIN 4 TO 7 PIN 8 TO 10 |
| RIGHT | PIN 3 TO 8 PIN 8 TO 9 PIN 4 TO 10 |
| DOWN | PIN 2 TO 8 PIN 7 TO 8 PIN 4 TO 10 |
| LEFT | PIN 3 TO 4 PIN 4 TO 9 PIN 8 TO 10 |
| MIRROR IN "R" POSITION | |
| UP | PIN 2 TO 4 PIN 4 TO 7 PIN 1 TO 8 |
| RIGHT | PIN 1 TO 4 PIN 3 TO 8 PIN 8 TO 9 |
| DOWN | PIN 1 TO 4 PIN 2 TO 8 PIN 7 TO 8 |
| LEFT | PIN 3 TO 4 PIN 1 TO 8 PIN 4 TO 9 |