WINDOW MOTOR
REMOVAL
1. Move the window to the full UP position, if possible.
2. Disconnect and isolate the battery negative cable.
3. Remove door trim panel (Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL - REMOVAL).
4. Disconnect electrical harness connector from motor.
5. Remove window regulator.
6. With regulator on bench, remove four screws retaining the motor to the regulator and remove motor.
INSTALLATION
1. With regulator on bench, install four screws retaining the motor to the regulator.
2. Install the window regulator.
3. Connect the electrical harness connector to window motor.
4. Install door trim panel (Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL - INSTALLATION).
5. Connect battery negative cable.