B223D-OCCUPANT CLASSIFICATION MODULE DTC PRESENT
- When Monitored:
With the ignition on.
- Set Condition:
This DTC will set if the ORC receives a bus message with the active OCM DTC Present bit set.
| Possible Causes |
| ACTIVE DTC IN OCCUPANT CLASSIFICATION MODULE (OCM) |
| OCCUPANT RESTRAINT CONTROLLER (ORC) |
Diagnostic Test
1. VERIFY THAT DTC B223D-OCCUPANT CLASSIFICATION MODULE DTC IS ACTIVEWith the scan tool, read the ORC active DTCs.
Does the scan tool display active: B223D-OCCUPANT CLASSIFICATION MODULE?
Yes
- Go To2
No
- With the scan tool, perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.
2. ACTIVE DTC IN OCCUPANT CLASSIFICATION MODULE
With the scan tool, read the OCCUPANT CLASSIFICATION MODULE active DTCs.
Are there any active DTC present?
Yes
- Refer to the symptom list for problems related to the OCM.
No
- Go To3
3. REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and personal injury or death.
If there are no possible causes remaining, view repair.
Repair
- Replace the ORC in accordance with Service Instructions.
- Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1.