OPERATION

OPERATION

When speed control is activated by depressing the ON switch, the PCM allows a set speed to be stored in RAM for speed control. To store a set speed, depress and release the SET switch while the vehicle is moving at a speed between 25 and 85 mph (40 km/h and 137 km/h). In order for the speed control to engage, the brakes cannot be applied, nor can the gear selector be indicating the transmission is in Park or Neutral (ATX) or 1st/2nd gear (MTX). The speed control can be disengaged manually by:

• Stepping on the brake pedal
• Depressing the OFF switch
• Depressing the CANCEL switch.
• Depressing the clutch pedal
• Operating in 1st or 2nd gear (autostick, if equipped)

NOTE: Turning the system off by depressing the OFF switch or turning off the ignition switch will erase the set speed stored in the PCM.

For added safety, the speed control system is programmed to disengage for any of the following conditions:

• An indication of Park or Neutral
• A rapid increase rpm (indicates that the clutch has been disengaged)
• Excessive engine rpm (indicates that the transmission may be in a low gear)
• The speed signal increases at a rate of 10 mph (16 km/h) per second (indicates that the co-efficient of friction between the road surface and tires is extremely low)
• The speed signal decreases at a rate of 10 mph (16 km/h) per second (indicates that the vehicle may have decelerated at an extremely high rate)
• If the actual speed is greater than 20 mph (32 km/h) over the set speed.
• Autostick shifts into 1st or 2nd gear (autostick, if equipped)

Once the speed control has been disengaged, depressing the RESUME switch when speed is greater than 20 mph (32 km/h) allows the vehicle to resume control to the target speed that was stored in the PCM.

While the speed control is engaged, the driver can increase the vehicle speed by depressing the ACCEL switch. The new target speed is stored in the PCM when the ACCEL switch is released. The PCM also has a tap-up feature in which target speed increases by 2 mph (3 km/h) for each momentary switch activation of the ACCEL switch. The PCM also provides a means to decelerate to a new lower target speed without disengaging speed control. Depress and hold the COAST switch until the desired speed is reached, then release the switch.

The PCM also has a Tap Down feature in which target speed decreases at 1 mph (1.5 km/h) for each momentary switch activation of the coast switch.

OPERATION - CHECKING FOR DIAGNOSTIC CODES

When trying to verify a speed control system electronic malfunction: Connect a scan tool if available to the data link connector. The connector is located near the steering column, and at lower edge of the dash panel.

A speed control malfunction may occur without a diagnostic code being indicated. For further information and usage of the scan tool and a more complete list of Diagnostic Trouble Code and No Trouble Codes, refer to the Powertrain Diagnostic.