CONTROL SWITCH
DESCRIPTION
Vehicles equipped with a power sunroof utilize a sunroof control switch. On this model, the sunroof control switch is located in the overhead console, in between the two reading lamps. The switch is mounted in the overhead console with four plastic retaining tabs, molded into the switch housing.
This switch incorporates six selections of operation open, auto open, close, auto close, auto vent and vent. The individual switches in the sunroof control switch unit cannot be repaired. If one switch is damaged or faulty, the entire sunroof control switch unit must be replaced.
OPERATION
With the operation of the sunroof control switch, voltage is directed to the sunroof motor, through the switch contacts or control module. If the control switch is depressed and held depressed the voltage signal is controlled manually through the switch contacts, so when the switch is released the sunroof stops.
Refer to the Owner's Manual for more information on the operation of the sunroof switch and system.
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the overhead console from the headliner (Refer to 8 - ELECTRICAL/OVERHEAD CONSOLE - REMOVAL).
3. Disconnect the sunroof control switch electrical connector. Depress the connector retaining tab and pull the connector straight out.
4. To remove the switch from the overhead console, push on the back of the switch until it comes free from the overhead console.
INSTALLATION
1. Install the switch in the overhead console assembly. Be certain the switch is securely snapped in place.
2. Connect the sunroof control switch electrical connector. Be certain the switch connector is securely snapped in place.
3. Install the overhead console (Refer to 8 - ELECTRICAL/OVERHEAD CONSOLE - INSTALLATION).
4. Connect the negative battery cable.