BOOT-GEAR SHIFT
REMOVAL
1. Pull up on gearshift knob (1) with moderate force to remove from gearshift mechanism.
2. Remove shifter boot/bezel (3) assembly from console by lifting up at mounting ring area.
INSTALLATION
1. Position gearshift boot (3) over the operating lever (2) and apply hand pressure to engage and snap console into place.
2. Position gearshift knob (1) hole over the gearshift mechanism and align the shift pattern.
3. Verify that shift pattern is aligned properly.
4. Strike knob (1) with rubber mallet to engage knob to mechanism.