B231F-FRONT/REAR WASHER MOTOR CONTROL CIRCUIT LOW
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
- With the ignition on.
- Set Condition:
- When the TIPM detects a short/low condition on the washer Pump Motor Control circuit.
| Possible Causes |
| (W10)/(W20) WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TOGETHER |
| (W10) WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TO GROUND |
| (W20) WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TO GROUND |
| WIPER WASHER PUMP |
| TOTALLY INTEGRATED POWER MODULE |
Diagnostic Test
1. INTERMITTENT CONDITIONTurn the ignition on.
With the Scan Tool, clear all TIPM DTC's.
Turn the Washers on.
With the Scan Tool, read the Wiper/Washers DTC's.
Does the Scan Tool read: B231F-FRONT/REAR WASHER MOTOR CONTROL CIRCUIT LOW?
Yes
- Go To 2
No
- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
2. WASHER PUMP MOTOR
Turn the ignition off.
Disconnect the Washer Pump Motor connector.
Turn the ignition on.
With the Scan Tool, read the DTC's.
Does the Scan Tool read: B231F-FRONT/REAR WASHER MOTOR CONTROL CIRCUIT LOW?
Yes
- Go To 3
No
- Replace the Washer Pump Motor in accordance with the service information.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
3. (W10)/(W20) WASHER PUMP MOTOR CONTROL CIRCUITS SHORT TOGETHER
Turn the ignition off.
Disconnect the Washer Pump Motor harness connector.
Disconnect the TIPM C1 harness connector.
Measure the resistance between the (W10) and (W20) Washer Pump Motor Control circuits.
Is the resistance below 5.0 ohms?
Yes
- Repair the (W10) and (W20) Washer Pump Motor Control circuits for a short together.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Go To 4
4. (W10) WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TO GROUND
Measure the resistance between ground and the (W10) Washer Pump Motor Control circuit.
Is the resistance below 5.0 ohms?
Yes
- Repair the (W10) Washer Pump Motor Control circuit for a short to ground.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Go To 5
5. (W20) WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TO GROUND
Measure the resistance between ground and the (W20) Washer Pump Motor Control circuit.
Is the resistance below 5.0 ohms?
Yes
- Repair the (W20) Washer Pump Motor Control circuit for a short to ground.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- Replace the Totally Integrated Power Module in accordance with the service information.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)