B2325-HEADLAMP WASHER MOTOR CONTROL CIRCUIT OPEN
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
- With the ignition on.
- Set Condition:
- When the TIPM detects a short/HIGH condition.
| Possible Causes |
| TOTALLY INTEGRATED POWER MODULE |
Diagnostic Test
1. TOTALLY INTEGRATED POWER MODULETurn the ignition off.
Replace the Wiper ON/OFF relay with and known good relay.
With the scan tool, clear all TIPM DTC's.
Turn the Wipers ON then OFF.
With the scan tool, read the Wiper DTC's.
Does the scan tool read: B2325–HEADLAMP WASHER MOTOR CONTROL CIRCUIT OPEN?
Yes
- Replace the Integrated Power Module in accordance with the service information.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING)
No
- Test complete.
- Perform the BODY VERIFICATION TEST — VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING)