U1108-ADDITIONAL CAN B ECU DETECTED
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
Continuously.
- Set Condition:
The Front Control Module detects an additional CAN B module and requires a reconfiguration.
| Possible Causes |
| ADDITIONAL MODULE ADDED/REMOVED FROM THE CAN B BUS NETWORK |
Diagnostic Test
1. RECONFIGURE THE FRONT CONTROL MODULETurn the ignition on.
With the scan tool, select network view and press the gateway button. This will list the CAN modules on the vehicle. Read and record the listed modules.
With the scan tool, select FCM, miscellaneous functions then add/remove ECUs.
With the scan tool, add or remove the module that was not configured in the FCM.
With the scan tool, erase DTC's.
Cycle the ignition from on to off 3 times and read the active FCM DTC's.
Does the scan tool display this DTC as active?
Yes
- Retest system and attempt to reconfigure the FCM.
- Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).
No
- Repair is complete.
- Perform BODY VERIFICATION TEST – VER 1. (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE).